Troubleshooting - JVC RX-80PGD Instructions Manual

Audio/video control receiver
Table of Contents

Advertisement

Troubleshooting

Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact
your JVC service center.
PROBLEM
POSSIBLE CAUSE
The display does not light
The power cord is not plugged in.
up.
No sound from speakers.
Speaker signal cables are not
connected.
The SPEAKERS 1 and 2 buttons
are not set correctly.
An incorrect source is selected.
Mute is activated.
Sound from one speaker
Speaker signal cables are not
only.
connected properly.
The balance is set to one extreme.
Continuous hiss or buzzing
Incoming signal is too weak.
during FM reception.
The station is too far away.
An incorrect antenna is used.
Antennas are not connected
properly.
Occasional cracking noise
Ignition noise from automobiles.
during FM reception.
The analog discrete output
An incorrect source is selected.
sound of the DVD player
cannot be reproduced
correctly.
The sound setting of the DVD
player is incorrect.
No colors on the on-screen
The color system of the
display.
connected TV is not PAL.
Howling during record
Your turntable is too close to
playing.
speakers.
Remote control does not
The remote control mode selector
work.
is not set correctly.
There is an obstruction in front of
the remote control sensor on the
receiver.
Batteries are weak.
SOLUTION
Plug the power cord into an AC outlet.
Check speaker wiring and
reconnect if necessary.
Press SPEAKERS 1 and 2 correctly.
(See page 13.)
Select the correct source.
Press MUTING to cancel the mute.
Check speaker wiring and reconnect if
necessary.
Adjust the balance properly.
Connect an outside FM antenna or
contact your dealer.
Select a new station.
Check with your dealer to be sure you
have a correct antenna.
Check connections.
Move the antenna farther from
automobile traffic.
Select "DVDMULTI" as the source on
the receiver.
Check the sound setting of the DVD
player.
Connect an PAL TV.
Move speakers away from the
turntable.
Set the selector correctly either to the
"TV / VCR / TUNER / CD / DVD /
VCD" position or to "SOUND
CONTROL" position.
Remove the obstruction.
Replace batteries.
Page 50

Advertisement

Table of Contents
loading

Table of Contents