gofanco Matrix88HD20-Pro User Manual page 6

Hardware Installation
1. Power off all devices including your HDMI sources
and HDMI displays.
2. Connect your HDMI source devices to the HDMI
IN (1-8) connectors with HDMI cables (HDMI cables
not included).
3. Connect your HDMI displays to the HDMI OUT (1-
8) connectors with HDMI cables (HDMI cables not
included).
4. Optional: Connect your PC to the Matrix Pro's RJ45
port using a CAT cable this connection is needed
only if you require device control via Web GUI. See
TCP/IP Control on page 12 for more information.
5. Optional: Plug the included IR Receiver cable into
the Matrix's IR Input connector, this connection is
needed only if the front panel IR sensor is blocked
and not responding to commands from the included
Remote Controller.
6 Optional: Plug the included RS232 cable into the
Matrix's RS232 connector then connect the other end
to an RS232 serial port of your computer, this
connection is needed only if you require RS232
device control via a computer system. See RS232
Control on page 22 for more information.
6. Plug the included power adapter into the power
jack then plug the power adapter into a reliable
power source.
7. Power on all connected devices.
8. The HDMI 8x8 Matrix is ready for use.
6