Data Collect: Coll(045) - Omron CVM1D Operation Manual

Hide thumbs Also See for CVM1D:

Table of Contents

Data Movement Instructions

5-15-15 DATA COLLECT: COLL(045)

Ladder Symbol

When the execution condition is OFF, COLL(045) is not executed. When the ex-

ecution condition is ON, COLL(045) copies the content of SBs + Of to D, i.e., Of

is added to SBs to determine the source word.

Of must be BCD.

Note Refer to page 101 for general precautions on operand data areas.

ER (A50003):

Of is not BCD.

Content of *DM word is not BCD when set for BCD.

EQ (A50006):

Content of S is 0.

Same status as bit 15 of D after execution.

When CIO 000005 is ON in the following example, the source word (CIO 0007) is

calculated by adding 5 (the content of CIO 0020) to the source base word

(CIO 0002). The content of CIO 0007 is then copied to the destination word

Operand Data Areas

SBs: Source base

CIO, G, A, T, C, DM

Of: Offset data

CIO, G, A, T, C, #, DM, DR, IR

D: Destination word

CIO, G, A, T, C, DM, DR, IR

Section 5-15

Address Instruction

Table of Contents