Table of Contents
Advertisement
SY365C LC Excavator OMM
NOTICE!
•
There are two 12-volt batteries connected in series to provide 24 volts to the electrical
system.
•
After machine shutdown, wait at least 1 minute for the Engine Control Module (ECM) to
complete its shutdown before disconnecting the battery.
Failure to follow this notice can damage the machine or cause it to operate improperly.
2. Turn the battery disconnect switch to the OFF position. See "Battery Disconnect Switch" on page 3-19.
3. Disconnect electrical power. See "Disconnect the Electrical Power" on page 5-57.
4. Remove the fasteners (2) and remove the battery cover.
5. Check the top surfaces and all battery connections (3)
for signs of corrosion or dirt buildup.
6. Use a clean rag to wipe any dirt from the batteries.
NOTE: If corrosion is found, flush the area with a
battery cleaning solution.
7. Remove any trash, tools, parts, or debris from the
battery compartment.
8. Install the cover.
9. Close left side access doors. See "Opening the Left Front Access Door" on page 4-9.
SANY
Fig. 5-70
Operation and Maintenance Manual — 0420
3
Maintenance
5-59
Advertisement
Table of Contents
