SANY SY365C LC Operation And Maintenance Manual page 176

Maintenance
5. Remove the engine oil dipstick (2) from the engine,
wipe it with a clean cloth, then insert the dipstick in its
holder.
NOTICE!
Do not add engine oil past the upper mark on
the dipstick, as this may result in engine
damage.
6. Remove the dipstick, note the oil level. Install the
dipstick.
NOTE: The oil level should be within the etched area
(3). If the oil is not within the etched area,
remove the engine oil filler cap, then add oil
until the level is within the etched area.
7. Start and run the engine at low idle for several minutes,
shut off the engine, and check for oil leaks.
8. Check the engine oil level. Add engine oil as needed.
9. Close engine compartment door.
5-24
Fig. 5-8
Fig. 5-9
Operation and Maintenance Manual — 0420
SY365C LC Excavator OMM
2
3
0005185
SANY