Quick BTAC Series Installation And User Manual page 11

4 - Installation
4.1 - Gearleg and motor support flange 250/300
• FIG. 1 Proceed with fitting the gearleg with the special seal
gasket. For further protection against the entry of water, apply
silicone for nautical use around the point of contact between
flange and tube. Fasten everything to the flange using the
special screws and washers.
FIG.2
• FIG. 2 Grease the terminal part of the gearleg shaft; fit the
small key into its seat.
• FIG. 4 Grease the terminal part of the drive shaft.
FIG.3
• FIG. 3 Insert the elastic joint in the terminal part of the
gearleg shaft.
• FIG. 5 Insert the motor onto the elastic joint; fasten it with
the 4 screws and washers provided.
QUICK BTAC SERIES INSTALLATION AND USER'S MANUAL - REV002A
BTAC Series
EN
11