Quick BTAC Series Installation And User Manual page 15

4 - Installation
4.4 -
Joint/motor assembly
• FIG. 1 Grease the terminal part of the gearbox.
• FIG. 2 Insert the lower half-joint, secure it with the snap ring (BTAC
513/610 only), and the cush drive damper into the end of the gearleg
shaft.
NOTE: On the BTAC 386HD C00, tighten the set screw of the lower
joint.
FIG.2
BTAC 386 B00
FIG.3
• FIG. 3 Grease the terminal part of the drive shaft and fit
the upper half-joint.
• FIG. 4 Fit the motor on the gearbox and secure it to the
support.
• FIG. 5 Tighten the screw of the upper joint, holding it
towards the gearbox.
BTAC 386HD C00
FIG.4
QUICK BTAC SERIES INSTALLATION AND USER'S MANUAL - REV002A
FIG.1
FIG.5
BTAC Series
BTAC 513/610
EN
15