Quick BTAC Series Installation And User Manual page 12

4 - Installation
EN
4.2 - Gearleg and motor support flange 386
• FIG. 1 Proceed with fitting the gearleg with the special seal gasket For further protection against the entry of water, apply
silicone for nautical use around the point of contact between flange and tube. Fasten the flange using the special screws and
washers: 2 screws for gearbox B00 - 4 screws for gearbox C00 HD.
• FIG. 2 Grease the terminal part of the gearleg shaft; fit the small key into its seat.
FIG.1
4.3 - Gearleg and motor support flange 513/610
FIG.1
• FIG. 1 Fit the gearbox with the special seal gasket.
• FIG. 2 Remove the cap on the gearbox and insert the fitting to later connect
the oil tank. Screw in and position the head of the fitting towards the inside
to facilitate assembly with the flange.
• FIG. 3 Proceed with fitting the gearleg. For further protection against the
entry of water, apply silicone for nautical use around the point of contact
between flange and tube. Fasten the flange using the special screws.
12
FIG.2
QUICK BTAC SERIES INSTALLATION AND USER'S MANUAL - REV002A
FIG.2
FIG.3
BTAC Series