Updating Of The Firmware - PIONEER DJ XDJ-XZ Service Manual

5

8.2 UPDATING OF THE FIRMWARE

Note:
If the power cord is disconnected during updating, perform updating again after the unit is turned on the next time.
Then you can operate the unit normally.
You cannot operate the unit normally without reperforming updating.
Procedure
1 Copy an update file (XDJXZ.UPD) to a root folder of USB device.
2 Turn on the power, pressing the USB1 "USB1 STOP", DECK 2 "CUE/LOOP CALL
service update mode for firmware.
(Be sure to hold the switch pressed until the unit starts up.)
3 Insert the USB device into the USB 1 slot which you wrote in an update file at with step 1.
4 Update is started.
5 Update is completed, and displayed "Firmware update is complete."
5
6
switch
XDJ-XZ
6
7
(LOOP 2X)" buttons, enter the
USB1 STOP button
CUE/LOOP CALL
(LOOP 2X) button
7
8
A
B
C
D
E
F
75
8