PIONEER DJ XDJ-XZ Service Manual page 64

1
Position adjustment of FX select knob
A
Fine adjustment of the position is necessary for the EFSW Assy. According to the following, you tighten a screw and confirm it.
EFSW Assy
B
Align the screw holes of the Control panel and
C
the board, and temporarily fix at this part.
[3-8] CHF1 to CHF4 Assys
1
Remove the 4 screws.
(BPZ20P060FTC)
2
Remove the CHF1 to CHF4 Assy with VR stay.
3
Remove the 2 screws.
(PMH20P040FTC)
4
Remove the CHF1 to CHF4 Assy.
D
5
Remove the 2 screws and then remove the
Guide shaft (S) and Slider base Section.
(CPZ26P080FTC)
6
Remove the Slider base Section from Guide
shaft (S).
7
Remove the 2 screws and then remove the
Lever plate Section.
(BPZ20P060FTC)
E
Locations of grease application
Note:
Lubricating oil
Greasing must be performed at a total of 8 points, 2 points
(GYA1001)
each for the upper and bottom places of each shaft.
(0.4 to 1 mg per point × 8 points)
After applying grease, move the slider base back and forth
from one end to the other for approximately 10 to 20 strokes,
in order to fully spread the grease.
F
64
1
2
Turn the knob Turn the knob
counterclockwise to the end clockwise to the end
Turn over and insert the knob. Because it is
temporarily fixed, it is necessary to prevent the
substrate from being loaded. (Ex: Hold the back of the board)
Rotate FX select knob in the direction of the arrow to the end.
At that time, confirm if it is not held at a position deviated
from the position of the command select part.
l If the knob is not held, it is OK.
If not, adjust the position of EFSW Assy and check again.
2
3
If it is held, adjust the
position with reference
to the Fig. on the right.
1 ×4 ×4
VR stay
7
×2 ×2
Lever plate
6
7
Slider base
Top & Bottom Top & Bottom
Top & Bottom
XDJ-XZ
3
4
Adjust the position while loosening the
screws on EFSW Assy so that the center
of the hole (yellow circle) of the panel
and the center of the encoder axis
(red circle) coincide.
3 ×2 ×2
CHF1 to CHF4 Assy
4
5 ×2 ×2
2
Shaft holder
Top & Bottom
4