Sun Microsystems StorEdge MultiPack-FC Installation, Operation And Service Manual page 59

2. Use the luxadm remove_device command to remove the disk from the Fibre
Channel Arbitrated Loop (FC-AL).
This command is interactive and will prompt you to physically remove the drive.
For example:
# luxadm remove_device /dev/rdsk/c3t8d0s2
WARNING!!! Please ensure that no filesystems are mounted on these
device(s).
All data on these devices should have been backed up.
The list of devices which will be removed is:
1: Device /dev/rdsk/c3t8d0s2
Please enter 'q' to Quit or <Return> to Continue:
stopping: /dev/rdsk/c3t8d0s0....Done
offlining: /dev/rdsk/c3t8d0s0....Done
Hit <Return> after removing the device(s).
Note – Do not press Return until Step 3 and Step 4 have been completed.
Note – If the luxadm remove_device command fails to remove the drive, use of
the luxadm remove_device -F option may be required. Be sure you have
stopped all input/output to the drive before using the -F option. Refer to the
luxadm Man Page for more information.
3. Open the drive access panel (FIGURE 3-8).
Chapter 3 Service 3-9