Using The Terminal For The First Time; Unpack The Terminal; Charge And Install The Battery Pack; Turn On The Terminal - Intermec Trakker Antares 241 Series Quick Start Manual

Note: Intermec recommends that you keep at least two battery packs on
hand so that you can use one battery pack while the other is recharging.
You should keep a battery pack in the terminal at all times to prevent the
loss of data.

Using the Terminal for the First Time

Once you have the required equipment, follow these steps to start using your
new terminal:
1

Unpack the terminal.

2
Charge and install the battery pack (sold separately).
3

Turn on the terminal.

4
Set the time and date.
5
(Optional) Configure the serial port parameters.
6
(2415 only) Configure the network parameters.
7
(2415 only) Configure the radio parameters.
These steps are described in detail in the next sections.
1 Unpack the Terminal
When you remove the terminal from its box, save the box and shipping material
in case you need to ship or store the terminal. Check the contents of the box
against the invoice for completeness. If there is a problem, contact your local
Intermec service representative.
2

Charge and Install the Battery Pack

Caution
The lithium-ion battery pack that is used in this device may present
a fire or chemical burn hazard if it is mistreated. Do not
disassemble it, heat it above 100ºC (212ºF) or incinerate it.
Conseil
Le bloc-batterie au lithium utilisé dans cet appareil peut présenter
un risque d'incendie ou de brûlure chimique en cas de mauvais
traitement. Ne désassemblez pas, ne chauffez pas à une
température supérieure à 100 °C (212 °F) et n'incinérez pas ce
bloc-batterie.
6
You must fully charge the lithium-ion battery pack before you can use the
terminal. The terminal will not operate without a battery pack.
To charge the battery pack
•
Place the battery pack in an empty slot in a battery charger. The battery pack
is fully charged in 2 to 4 hours. For help, see the documentation that came
with your battery charger.
You can also use the communications dock that is connected to a power supply
to charge the battery pack. For help, see the Trakker Antares TD2410
Communications Dock Quick Reference Guide (P/N 069552).
Replace the battery pack with P/N 069428 or P/N 069429 only. The use of any
other battery pack may present a risk of fire or explosion. Contact your local
Intermec sales representative for replacement main battery packs. DISPOSE OF
USED BATTERY PACKS PROMPTLY. KEEP THEM AWAY FROM
CHILDREN.
To install the battery pack
3
Turn On the Terminal
The Suspend/Resume key is the _ key in the middle of the bottom row of the
keypad. When you press _ to turn off the terminal, the terminal does not
actually shut off, but it goes into a Suspend mode. When you press _ to turn on
the terminal, you can configure the terminal either to resume exactly where it
was when you turned it off or to boot and restart your application.
241XG010.eps
7