Changing The Beep Volume; Learning About The Status Icons - Intermec Trakker Antares 2430 Quick Start Manual

C d 39 nuggetfont
code labels. Only enable the bar code symbologies that you need
to scan.

Changing the Beep Volume

The 243X has a beeper that provides you with audio feedback.
To change the beep volume
Press l t 2 4 8 , l x 2 4 8 ,
•
or the orange > key and then * 2 4 8 to access
the TRAKKER Antares 2400 Menu System. Choose
Configuration Menu > Terminal Menu > Beeper.

Learning About the Status Icons

You can use the status icons on the right side of the screen to
monitor the status of battery power, special keys, and network
communications. These icons only turn on to indicate current
status and are disabled by default.
To enable the status icons
1 Press l t 2 4 8 , l x 2 4 8 , or the
orange > key and then * 2 4 8 to access the
TRAKKER Antares 2400 Menu System.
2 Choose Configuration Menu > Terminal Menu > Display.
3 Set the Display Video Mode command to normal display
with icons (Nrm/Icon) or inverse display with icons
(Inv/Icon).
Status Icon Descriptions
Icon Name
Battery
Network
Connect
Network
Transmit
16 Trakker Antares 243X Handheld Terminal Quick Start Guide
Description
This icon turns on when there is a low battery
charge and the terminal is on.
This icon tells you if the 2435 is connected to
your network. The Network Connect status
icon may be off, blinking, or on.
This icon turns on when data is buffered in
the RF network interface.