Time Zone Configuration Command - Intermec Trakker Antares 2400 User Manual

Time Zone Configuration Command

Terminals: 241X, 242X, 243X, 2455, 2475, and 248X.
Description: The Time Zone configuration command sets the time zone on Trakker
Syntax: DZdata
Menu System: Not supported
10
Check the Network-EAP check box for Accept Authentication
b
Type.
Click OK.
c
3 On your Trakker Antares terminal, set the User Name and Password
parameters.
Scan this bar code to access the TRAKKER Antares 2400 Menu
a
System:
TRAKKER Antares 2400 Menu System
*..-.*
*..-.*
The Main Menu appears.
Choose Configuration Menu > Communications Menu > Radio.
b
Use the arrow keys to scroll to the LEAP screen and set the User
c
Name and Password parameters.
If you just want to make sure that your terminal can be authenticated,
you can use the default values of "anonymous" and "anonymous."
However, Intermec recommends that you set your permanent user
name and password to unique values. For help, see Chapter 6,
"Configuration Command Reference," in the 2400 Family system
manual.
4 Exit the menu system and save all changes.
5 When the terminal is authenticated, it emits a low beep and then a high
beep. The application that was running on the terminal, if any, resumes.
If authentication fails, the terminal emits a high beep and then a low
beep. The terminal waits 60 seconds and restarts the authentication
process.
Antares terminals. With firmware version 8.02, you can now set the time
zone using positive or negative values from -14 to +14 in increments of 15
minutes from 0, which represents Universal Time (UT).
Acceptable values for data are:
+/- + or - Positive or negative
hh 0 to 14 Hours
:mm 15, 30, or 45 Minutes (optional)
Trakker Antares Firmware Version 8.02 Addendum