Intermec Trakker Antares 2400 User Manual page 120

Index
troubleshooting
802.1x security, configuring, 73 to 75
antenna, replacing, 87
audio signals, list of, 24
bar code symbologies, 80, 81
batteries, 82
Boot Menu, using, 84
cleaning the terminal, 89
configuring the terminal, 69 to 72
DCS 30X, 79
guide to finding problems, 66
Intermec Gateway, 79
locked up application, 85
operating the terminal, 67 to 68
preventive maintenance, 87
resetting the terminal, 85
RF network communications, 75
running applications, 77
scanning bar code labels, 79 to 81
serial communications, 78
terminal locked up, 68
terminal will not turn on, 67
turning on the terminal
q key, described, 18
troubleshooting, 67
typing characters on the keypad, 17
TZ2400 Battery Charger, See battery charger
U, V, W
UDP Plus network
access points, configuring, 57
checking the protocol loaded, 36
DCS 30X, configuring, overview, 56
illustrated, 48, 49, 51
Intermec Gateway, configuring, overview, 56
parameters, listed, 58
unpacking the terminal, 8
upgrading the firmware, Boot Menu, using, 84
using
scan module, 26
terminal emulation keypads, 21
vehicle-mount holder, terminal accessory, described, 5
vertical reading angle for scanning, 27
volume, adjusting, 24
VT/ANSI terminal emulation, See the TE 2000
VT/ANSI Terminal Emulation Programmer's
Guide
wands, list for input device module, 95
warm boot, 85
Wavelink Avalanche, See the Trakker Antares 2400
Family System Manual.
what's new in this revision, 6
white keys, using, 18
wireless communications, See RF communications
WTP network
access points, configuring, 57
checking the protocol loaded, 36
DCS 30X, configuring, overview, 56
illustrated, 48
106
Intermec Gateway, configuring, overview, 56
parameters, listed, 58
Trakker Antares 242X Handheld Terminal User's Manual