Unpack The Terminal; Charge And Install The Battery Pack - Intermec Trakker Antares 2410 Quick Start Manual

C d 39 nuggetfont
6 (2415 only) Configure the network parameters.
7 (2415 only) Configure the radio parameters.
These steps are described in detail in the next sections.

Unpack the Terminal

When you remove the terminal from its box, save the box
and shipping material in case you need to ship or store the
terminal. Check the contents of the box against the invoice for
completeness. If there is a problem, contact your local Intermec
service representative.

Charge and Install the Battery Pack

The lithium-ion battery pack that is used in this
device may present a fire or chemical burn hazard
if it is mistreated. Do not disassemble it, heat it
above 100°C (212°F) or incinerate it.
Attention: Le bloc-batterie au lithium utilisé dans
cet appareil peut présenter un risque d'incendie
ou de brûlure chimique en cas de mauvais
traitement. Ne désassemblez pas, ne chauffez pas à
une température supérieure à 100°C (212°F) et
n'incinérez pas ce bloc-batterie.
You must fully charge the lithium-ion battery pack before you
can use the terminal. The terminal will not operate without a
battery pack.
To charge the battery pack
•
Place the battery pack in an empty slot in a battery charger.
Depending on the battery pack you have installed, the battery
pack is fully charged in 1.25 to 9 hours. For help, see the
documentation that came with your battery charger.
You can also use the communications dock that is connected to
a power supply to charge the battery pack. For help, see the
Trakker Antares TD2410 Communications Dock Quick Reference
Guide (P/N 069552).
Trakker Antares 241X Handheld Terminal Quick Start Guide 7