Intermec CN30 User Manual page 164

Chapter 3 — Configuring the CN30
152
To enable LEAP with WPA encryption:
1 Set 8021x Security as "LEAP."
2 Set Association to "WPA." Skip Encryption as it is automatically set to
"TKIP."
3 Enter your unique Username to use this protocol.
4 Select Prompt for password to have the user enter this password each
time to access the protocol, or leave Use following password as selected
to automatically use the protocol without entering a password.
To enable LEAP with WPA2 encryption:
1 Set 8021x Security as "LEAP."
2 Set Association to "WPA2."
3 Set Encryption to either "TKIP" or "AES."
4 Enter your unique Username to use this protocol.
5 Select Prompt for password to have the user enter this password each
time to access the protocol, or leave Use following password as selected
to automatically use the protocol without entering a password.
CN30 Mobile Computer User's Manual