Intermec CN30 User Manual page 144

Chapter 3 — Configuring the CN30
132
WPA runs in Enterprise (802.1x) mode or PSK (Pre-Shared Key) mode:
• In Enterprise mode, WPA provides user authentication using 802.1x and
the Extensible Authentication Protocol (EAP). That is, an authentication
server (such as a RADIUS server) must authenticate each device before
the device can communicate with the wireless network.
• In PSK mode, WPA provides user authentication using a shared key
between the authenticator and the CK31. WPA-PSK is a good solution
for small offices or home offices that do not want to use an authentica-
tion server.
To use WPA security, you need:
• an authentication server (Enterprise mode only). Note that you can also
use a MobileLAN access point with software release 1.80 or later as an
authentication server. For help, see the MobileLAN access WA2XG System
Manual (P/N 074921).
• an access point with an 802.11b/g radio that supports WPA.
• a CN30 Computer with the 802.11b/g radio and the 802.1x/WPA secu-
rity option.
Configuring WPA Security With Funk Security
Use this procedure to set WPA security on your CN30 Computer with
Funk security.
1 Make sure you have configured the communications and radio parame-
ters on your CN30 Computer and that Funk is your security choice.
2 Open Intermec Settings. Tap (+) to expand Communications > 802.11
Radio > Funk Security > Profile X with "X" being "1" through "4."
3 For Association, select "WPA" and press Enter. Encryption automati-
cally defaults to TKIP.
4 For 8021x, select "TTLS," "PEAP," or "TLS" and press Enter.
If you select "TTLS" or "PEAP:"
a Select User Name, type your user name, then press Enter.
b Select User Password, type a user password, then press Enter.
CN30 Mobile Computer User's Manual