Capturing The Edid; Capturing The Edid From A Display Device - Kramer WP-110XL User Manual

Uxga/data line transmitter

Hide thumbs Also See for WP-110XL:

Table of Contents

Capturing the EDID

The WP-110x can capture an EDID from a connected display or can load a default

EDID when no display is available or the unit cannot capture the EDID from the

connected display.

5.1

To capture an EDID from a display:

1. Using a Philips screwdriver, remove the four screws holding the faceplate to

the PCB assembly.

2. Using a short cable (for example, Kramer model number C-MGM/MGM-1),

connect the PC IN input 15-pin HD connector on the WP-110xl to the 15-pin

HD connector of the display and turn the display on.

3. Connect the 12V DC power adapter to the power terminal block (see

Figure

4. Press the EDID capture button (item 1 on

The EDID status LED (item 2 on

several times. The new EDID is captured when the LED stops flashing and

lights solid.

Note: If the status LED flashes quickly for a few seconds and then stays on

solid, the WP-110xl could not capture the EDID and loaded the default EDID

instead.

5. Unplug the power adapter from the mains and disconnect it from the

WP-110xl.

6. Replace the faceplate and secure the four screws removed in Step 1.

WP-110xl - Capturing the EDID

1) on the WP-110xl and connect the adapter to the mains electricity.

Figure 5

and

Figure 5

and

Figure

6).

6) flashes slowly

Table of Contents