Troubleshooting
Troubleshooting Table
This Troubleshooting table lists conditions you might see
and offers some basic remedies:
Condition
Low Battery
Low Battery
When The ON Key
Is Pressed The Dis-
play Is Blank.
Batteries Will Not
Charge
Printer Not Ready
Will Not Turn On
When The ON Key
Is Pressed
4-2
6212 Hand-Held Computer User's Guide
Table 4-1
Basic Troubleshooting
Solution
Recharge main Li Ion pack.
Recharge main Li Ion pack.
Charge immediately! Data loss is immi-
nent. If the application is displayed
when charge is applied both the main
and backup batteries were too low to run
the computer but the data has been
maintained.
If your computer resets itself when
charge is applied and returns to the Ad-
vanced Utilities program, the data was
lost. You may need to reload the applica-
tion.
This problem can occur if the battery
pack drops below a certain voltage. Do
these two things:
* Replace with new charged battery
pack.
* Reboot computer.
* Check to make sure there is power to
printer.
* Check cable connections.
* Check for paper jam.
* Check to make sure there is paper in
paper compartment.
* Ensure that there is a main battery
installed.
* Ensure that the main battery is
charged.
* Adjust contrast.
SECTION 4