Insinger GalleyMaster 135-LH-E Technical Manual page 21

þ
NOTE:
This section covers actions that can be
performed by the operator, without the use
of tools.
OPERATOR'S TROUBLESHOOTING GUIDE
SYMPTOM OF TROUBLE
1. Machine will not operate.
2. Tank will not hold water.
3. Tank fills beyond overflow level.
4. Water leaks from around door.
5. Weak or ineffective wash or rinse
spray.
6. Weak or ineffective final rinse spray.
7. Poor washing results.
8. Conveyor overload stops conveyor
motion.
9. Tank and/or booster will not hold
specified temperature.
GalleyMaster DOC Revision 2006
PART 4 MAINTENANCE & REPAIR PROCEDURES
POSSIBLE CAUSE
a. No power.
b. Control circuit breaker tripped.
a. Drain overflow tube not installed.
b. Pump petcock opened.
c. Drain not closed.
a. Obstruction in drain overflow tube.
b. Clogged drain line.
a. Door is not seated.
b. Clogged spray pipes.
a. Clogged spray pipes.
b. Manifolds not installed properly.
c. Suction strainer clogged.
a. Lime deposit on spray nozzles.
b. Low water pressure.
c. Closed supply valve.
a. Scrap screens clogged.
b. Pump suction strainer clogged.
c. Spray arms clogged.
a. Foreign object caught in conveyor
chain.
For Electric Heat:
a. Booster power off.
b. Tank power off.
c. Control power off.
d. Tank empty or low.
For Steam Heat:
e. Steam turned off.
f. Control power off.
g. Tank empty or low.
20
SOLUTION
a. Move POWER switch to ON.
b. Reset circuit breaker.
a. Install drain overflow tube.
b. Close pump petcock.
c. Close drain.
a. Remove obstruction
b. Remove drain overflow tube
(water is HOT!),if water does not
drain, maintenance must "snake"
drain line.
a. Check for proper seating.
b. Clean with brush provided.
a. Clean with brush provided.
b. Ensure proper placement of upper
and lower manifolds.
c. Clean suction strainer.
a. Clean nozzles.
b. Should be 20 PSI flowing.
c. Open valve.
a. Remove and clean screens.
b. Remove and clean suction
strainer.
c. Clean with brush provided.
a. Remove object.
For Electric Heat:
a. Check circuit breaker.
b. Check circuit breaker.
c. Turn control power switch on.
d. Fill tank.
For Steam Heat:
e. Turn steam supply on.
f. Turn contol power switch on.
g. Fill tank.
www.insingermachine.com 800-344-4802