Armrests (Option); Adjusting The Arm Support Height - Otto Bock Discovery Instructions For Use Manual

Fastening the calf band
1) Open all hook-and-loop closures on the calf band.
2) Route the calf band around the legrest holder and fasten the hook-and-loop (see fig. 49, item 1).
INFORMATION: If there is no holder for a calf band on the legrests, route the calf band around the
legrest bar and fasten it securely (see fig. 50, item 1).
3) Adjust the length and fasten the hook-and-loop closure (not illustrated).
49

7.7 Armrests (option)

CAUTION
Pinching at the side panels
Pinching, crushing due to lack of caution in danger areas
► Pay attention not to pinch parts of your body between the side panel or frame parts.

7.7.1 Adjusting the arm support height

The height of the armrest can be adjusted without the use of tools:
1) Loosen the clamping screw on the armrest (see fig. 51, item 1).
2) Slide the armrest to the desired height (see fig. 51, item 2).
INFORMATION: The armrest can also be removed entirely to make getting into the product easier. Do
this by pressing the tripod spring (see fig. 51, item 3) and pulling the armrest out of the armrest hold­
er. After getting in, reinsert the armrest in the armrest holder at the desired height.
3) Firmly tighten the clamping screw on the armrest (see fig. 51, item 1).
4) Verify that the armrest is firmly engaged.
51
Discovery
50
Use
33