Otto Bock Genium 3B1-3 Instructions For Use Manual page 54

Appendices
Beep signal
30 x long
–
Error while charging the product
LED on Status LED
power sup­ on battery
ply charger
Status LED Charging status indicat­
The LED
ring is lit in
weak purple
The LED
ring is lit up
yellow
54
Vibration signal
1 x long, 1 x short
repeated every 3 seconds
Continuous
Error
Country-specific plug adapter not fully
engaged on power supply
Non-functional socket
Defective power supply
No connection between battery charger
and power supply
Defective battery charger
or (5 LEDs)
No LED is lit
LED 2 and 4 are lit up
LED 1, 3 and 5 are lit up
LED 3 is lit up
Result
Severe error/indication
of safety mode activa­
tion (see Page 46)
e.g. one or more sensors
are not operational.
Total failure
Electronic control
longer possible. Safety
mode active or undeter­
mined valve state.
Undetermined product
behaviour.
Resolution
Check whether the country-specific plug
adapter is fully engaged on the power
supply.
Check socket with another electric appli­
ance.
The battery charger and power supply
must be inspected by an authorised
Ottobock Service Centre.
Check whether the charging cable plug is
fully engaged on the battery charger.
The battery charger and power supply
must be inspected by an authorised
Ottobock Service Centre.
Error
Distance between battery
charger and receiver of the
charging unit on the pros­
thesis too great. If the dis­
tance is more than 2 mm,
the prosthesis cannot be
charged.
Charger excess temperat­
ure
Excessively high or low
temperature of the pros­
thesis
The prosthesis is not being
charged
Distance between battery
charger and receiver of the
charging unit too great.
Required action
Attempt to reset this error by
connecting/disconnecting the
battery charger.
If the error persists, use of the
product is prohibited. The
product must be inspected by
an authorised Ottobock Ser­
vice Center.
Attempt to reset this error by
connecting/disconnecting the
no
battery charger.
If the error persists, use of the
product is prohibited. The
product must be inspected by
an authorised Ottobock Ser­
vice Center.
Resolution
Reduce distance between
battery charger and receiver
of the charging unit.
Check whether the spe­
cified ambient conditions for
charging the battery are met
(see Page 49).
Connection may
improved by reducing the
distance between the char­
ger and receiver of the char­
ging unit.
Genium 3B1-3/3B1-3=ST
be