Figure 72: ASI Output Settings
2.
Activate an ASI Output by selecting "ON" in the corresponding virtual switch "Output enabled".
NOTE: Alternatively, you can activate ASI output under Codec Settings→TS Multiplexer in the "Multiplexer
Outputs" block (tab "ASI Output").
3.
In the dropdown menu "Output signal" assign to each output one preset for transport stream Multiplex 1-8 that
should be sent over ASI output (more information about TS Multiplex configuration see section 13.3.1 "Output
TS Multiplexer" on page 47).
4.
Save the changes after each configuration by clicking "Save".
User Manual IP-4c V1.96
94