Table of Contents
Advertisement
3.
In the "Codec" block set PCM for decoder type and make the following configuration for the decoder (see red
frame in Figure 62) :
NOTE: Set exactly the same values as listed here.
Decoder type:
Audio mode:
Sampling rate:
Sampling width:
Endianness:
The remaining parameters can be configured with other values.
4.
Assign the corresponding Input Source configured for AES67 to a decoder as described in Section 14.1 "Assign
and Activate Source Streams" on page 65.
NOTE: You can drag and drop the "Input Sources" presets directly to the decoder (see red frames in Figure 63).
Figure 63: Decoder Input Setup for AES67/Dante Stream
5.
Click the "Save" button to save the settings.
The IP-4c is now decoding digital/analog audio from the AES67 input stream.
User Manual IP-4c V1.96
PCM
Stereo
48 kHz
24 Bit
Big Endian
85
Advertisement
Table of Contents
