Table of Contents
Advertisement
NOTE: The IP-4c can also operate as a transcoder and change the codec format of an input audio
stream. For transcoding, assign the corresponding input stream to the encoder and configure the
format of the output stream (see section 13.3 "Set up Encoder Outputs" on page 46).
To activate und to configure the encoder:
1.
Select Codec Settings→Codec in the web interface menu and open tab "Encoder":
Figure 22: Encoder Configuration
2.
In the "Source/Profile Assignment" block assign a preconfigured "Input Source" in the dropdown menu or drag
and drop the "Input Source" from the "Input Sources" block to each Encoder 1-8.
NOTE: The source for each Encoder 1-8 can be any "Input Source". You can assign the same audio input to
several encoders (also for option Stream4Sure).
NOTE: Input failure can be signaled by sending alarm via SNMP, LED or switching GPO (Relay).
To set up alarm control for the inputs see section 15.2 "Set up Monitoring for Audio Inputs" on
page 75.
For example, Encoder 1 and Encoder 2 can process an audio signal from audio input 1 (interface
[D IN 1/A-L IN 1-2], see section 9.2).
3.
Assign a preconfigured "Codec Profile" in the dropdown menu or drag and drop the "Profile" from the "Profiles"
tab (see Figure 22) to each Encoder 1-8.
4.
Click the "Save" button to save the changes.
User Manual IP-4c V1.96
45
Advertisement
Table of Contents
