Table of Contents
Advertisement
NOTE: To configure the IP outputs Data 1/2 open Network Settings→TCP/IP and see section 10.1.
7.
Click the „Save" button to save the changes or „Cancel" to restore the last settings.
13.3.1.3. TS Multiplexer Output over ASI (optional)
If available, you can use ASI output for each multiplexed stream Multiplex 1-8 for the same stream content and the
same destination as a redundancy or send different stream contents to the same or different destinations.
Set up ASI output for TS Multiplex 1-8 under Codec Settings→TS Multiplexer as follows:
1.
To configure ASI output for the corresponding Multiplexer, open the "ASI Output" tab in the "Multiplexer
Outputs" block (see red frame in Figure 29).
Figure 29: Activate ASI output for a TS Multiplex
2.
Activate the ASI output stream by selecting "ON" in the virtual switch or under Interface Settings→ASI Output
3.
Assign the corresponding ASI output to a TS Multiplex 1-8 under Interface Settings→ASI Output (see Figure 72:
ASI Output Settings on page 94).
For more information, see section 17.6 "ASI Output" on page 93.
Activation of the virtual switch "Active" under Codec Settings→TS Multiplexer or "Output enabled" under Interface
Settings→ASI Output makes the changes immediately valid. No "save the changes" confirmation is necessary.
13.3.2. Output Elementary Streams
For the output "Elementary Streams" you can predefine up to 64 output streams (destinations) over [Data 1/2]
interfaces.
Each "Elementary Stream" output can be assigned to one preconfigured Encoder 1-8 (see 13.2 "Assign Input
Source/Codec Profile" on page 44) and to Ethernet outputs Data 1 or Data 2.
User Manual IP-4c V1.96
53
Advertisement
Table of Contents
