2wcom IP-4c User Manual page 51

Domain Name/IP:
Port:
Multicast TTL
IP interface:
Mode:
Send Delay:
Pro-MPEG FEC:
Dual streaming:
NOTE: To configure the IP outputs Data 1/2 open the menu Network Settings→TCP/IP and see
section 10.1.
6. Enter the following data in the fields of the configuration of one TS/SRT destination in the "Edit" menu of the
"TS/SRT" tab (see Figure 28):
Activation:
Name:
Mode
Host
Auto-configure
source port:
Destination Port:
IP interface:
User Manual IP-4c V1.96
Define the IP for a destination.
Specify the port number of the destination.
TTL (Time to Live) for multicast packets
Select the interface for the output: Data 1/2.
Select mode of the output stream in the dropdown menu: RTP or UDP.
NOTE that besides the RTP also the RTCP packets are generated for the encoder output and
are sent in 5 second intervals. RTP allows reordering packets by means of sequence numbers.
Set up the send delay time in ms, which the encoder should wait in order to send Audio over
IP as an offset stream for redundancy.
Enable "Forward Error Correction" by selecting "ON" in the virtual switch ((for more
information see section 13.5 "Set up FEC for Encoder" on page 58).
NOTE: Activate Pro-MPEG FEC in the corresponding decoder.
Enable by selecting "ON" in the virtual switch. The configuration menu will be extended to
"Dual streaming" menu. Set up connection for dual streaming.
Configure the IP parameters for Dualstreaming. For the Ethernet input you can set up the
same or different sources Data 1/2.
NOTE: Activate Dual streaming in the corresponding decoder.
Activate this output stream by selecting "ON" in the virtual switch.
Enter the name of the stream for better reference.
You can use SRT in listener and caller mode
Enter the host domain of the SRT destination.
Activate automatic configuration of the source port by selecting "ON".
If deactivated: enter the port number manually (relevant for e.g. Firewall).
Specify the port number of the destination.
Select the interface for the output: Data 1/2.
51