Table of Contents
Advertisement
Figure 16: Input Source for coder – SRT
Name:
Mode:
Port:
IP interface:
Latency (ms):
Use Encryption:
Encryption:
Passphrase:
3.
Assign an available codec profile in the "Decoder Profile" dropdown menu. To predefine the codec profiles for
Decoder click the
section 13.1 "Preset Codec Profiles" on page 43).
4.
Set up a value for audio buffer in the decoder in ms (for more information about buffer see section 19 "Buffer
Delay Management" on page 102).
5.
Click the "Save" button to save the changes.
User Manual IP-4c V1.96
Enter the name of the input stream for better reference.
You can use SRT in listener and caller mode.
Specify the port number for SRT connection.
Select the interface for SRT connection: Data 1/2.
Define the time interval for the latency (milliseconds) before
the IP-4c starts to decode the signal distributed via SRT
protocol.
To protect your content from contribution to distribution
activate end-to-end encryption by switching "ON".
Available options: 128/192/256 bit AES (Advanced
Encryption Standard).
The type of AES encryption determines the length of the key
(passphrase). AES-128 uses a 16-character (128-bit)
passphrase, AES-192 uses a 24-character (192-bit) and AES-
256 uses a 32-character (256-bit) passphrase.
Enter a (defined) password used to secure the SRT stream.
icon or in the „Profiles" tag under Codec Settings→Codec (for more information see
37
Advertisement
Table of Contents
