I Auto Repeater Function - Icom IC-T81A Instruction Manual

I Auto repeater
function
(USA version only)
The USA version automatically activates the repeater settings
(duplex, ON/OFF, duplex direction, tone encoder ON/OFF)
when the operating frequency falls within or outside of the
general repeater output frequency range. The offset and re-
peater tone frequencies are not changed by the auto repeater
function, reset these frequencies, if necessary.
➀
While pushing [MULTI], push
[PWR] to turn power on and enter
initial set mode.
➁
Push [MULTI(↕)] one or more times
until "Ar" appears.
➂
Push [MULTI(↔)] (or rotate [DIAL]
to select the desired condition.
• "OFF"—the auto repeater function is
turned off;
"ON1"—the auto repeater function ac-
tivates for duplex only;
"ON2"—the auto repeater function ac-
tivates for duplex and tone.
➃
Push [VFO] to exit initial set mode.
INITIAL SET MODE
USING
DUP
Activates for duplex
only.
DUP T
Activates for duplex
and tone.
Auto repeater function
is turned off.
REPEATER OPERATION
Frequency range and offset direction
FREQUENCY RANGE
145.200– 145.495 MHz
146.610– 146.995 MHz
147.000– 147.395 MHz
442.000– 444.995 MHz
447.000– 449.995 MHz
51.620– 51.980 MHz
52.500– 52.980 MHz
53.500– 53.980 MHz
1282.000– 1287.995 MHz*
1288.000– 1295.000 MHz
*When operating in this range, the offset frequency must be set to
–12 MHz (see previous page for setting an offset).
5
DUPLEX DIRECTION
"–DUP" appears
"DUP" appears
"DUP" appears
"–DUP" appears
"–DUP" appears
"–DUP" appears
17