I Setting Tuning Steps - Icom IC-T81A Instruction Manual

4
BASIC OPERATION
D Via the keypad
(from the decimal point)
➀
Push [VFO] to select VFO
mode.
➁
Push [•] to leave the MHz
setting as is and input from
the kHz digits.
D Other methods
➥
Via the [DIAL]: Rotate [DIAL] to change the frequency ac-
cording to the set tuning steps.
➥
Via the MHz STEP: Push [
tate [DIAL] to change the frequency in 1 MHz steps.
10
[Example]
.
5
8
0
MHz] for 1 sec., then ro-
(VFO)

I Setting tuning steps

The transceiver has 9 tuning steps* (each band has indepen-
dent settings) as follows:
5 kHz 10 kHz 12.5 kHz
25 kHz 30 kHz 50 kHz
*The 5 and 15 kHz steps are not available on the 1200 MHz band.
➀
Push [VFO] to select VFO mode.
➁
Push [MULTI(↔)] to select the desired band.
➂
Push [MULTI] for 1 sec. to enter set mode.
➃
Push [MULTI(↕)] one or more times
until "TS" appears.
➄
Push [MULTI(↔)] (or rotate [DIAL])
to select the desired tuning step.
➅
Push [VFO] to exit set mode.
✔CONVENIENT
Select a tuning step that matches the frequency intervals of
repeaters in your area.
SET MODE
USING
15 kHz 20 kHz
100 kHz
15 kHz tuning step
25 kHz tuning step