I Memory Scan Operation; I Select Memory Scan - Icom IC-746PRO Instruction Manual

I Memory scan operation (Memory mode)
Memory scan searches through memory channel 1 to
99 for signals. Blank (unprogrammed) memory chan-
nels are skipped.
q Push [V/M] to select memory mode, if necessary.
w Push [MENU] to select
e Push [F1
] to select the scan menu.
• See p. 69 for scan condition.
• If the [RF/SQL] control function is set as "AUTO," the
squelch is always open in SSB, CW and RTTY modes.
r Push [F1
] to start the memory scan.
• The MHz and kHz decimal points blink while scanning.
• At least 2 memory channels must be programmed for
memory scan to proceed.
t To cancel the scan, push [F1
• Rotating the tuning dial during scan also cancels scan
operation.

I Select memory scan

Select memory scan searches through memory chan-
nels set as "select," for signals. See below for setting
and deleting select memory channels.
q Follow the steps q to r above to start memory
scan.
w During memory scan, push [F3
tween memory scan and select memory scan.
• At least 2 memory channels must be set as the select
channel.
e Push [F1
] to cancel the scan.
• Rotating the tuning dial during scan also cancels scan
operation.
D D Setting/Cancelling select memory channels
All memory channels, except scan edges (P1 and P2),
can be set as a select memory channels.
➥ While the scan menu is selected, push [F3
set/cancel the displayed memory channel as a se-
lect channel; or while memory name screen is indi-
cated, push [F5 ] to set/cancel the displayed
memory channel as a select memory channel.
• "SEL" appears when the channel is set as a select mem-
ory channel.
• "SEL" disappears when cancelled.
• Push [F3 ]/[F5
memory settings.
.
].
] to switch be-
] to
] for 1 sec to cancel all select
[MENU]
∂
F 1 F 2 F 3
Push [F1] to start/cancel the scanning.
∂
F 1 F 2 F 3
Push [F3] to switch
between memory scan
and select memory
scan.
∂
F 1 F 2 F 3
• Scan menu
∂
F 1 F 2 F 3
Push [F3] to set/cancel as a select channel.
Select memory inidcator
• Memory name screen
F 1 F 2 F 3
Push [F3] to set/cancel as a select channel.
8
SCANS
[V/M]
Tuning dial
F 4 F 5
F 4 F 5
F 4 F 5
∂
F 4 F 5
F 4 F 5
72