IBM 1U Installation And Maintenance Manual page 48

10. Tighten the two rail-adjustment screws on each of the outer rails if you
11. Loosen the front four slide-rail bracket screws, and then insert the
38
1U 17-inch Flat Panel Console Kit: Installation and Maintenance Guide
9. Loosely attach the back of the slide-rail brackets to the rack cabinet, using four
screws. Make sure that the slide-rail brackets extend outside of the
rack-cabinet mounting flanges.
loosened them in step 7 on page 37.
rail-alignment spacer into the middle holes in the slide rail. The rail-alignment
spacer must wrap around the rails to align them correctly. Tighten the front four
screws and remove the spacer.
Rail-alignment spacer