IBM 1U Installation And Maintenance Manual page 42

13. Fasten the keyboard-and-mouse cable to the console unit with the nut and
14. Route the keyboard-and-mouse cable and the other cables through the
15. Reconnect the keyboard-and-mouse cable to the server or console switch.
16. Carefully lift the flat-panel display to the full upright position.
32
1U 17-inch Flat Panel Console Kit: Installation and Maintenance Guide
clamp:
a. Push the keyboard-and-mouse cable into the clamp that you removed in
step 4 on page 27.
Important: Make sure that you place the clamp on the
keyboard-and-mouse cable approximately 70 - 76 mm (2.75 -
3 in.) from where the cable exits the keyboard. This prevents
the cable from hanging below the bottom of the console unit.
Note: The following illustration shows the underside of a fully extended
console unit that is installed in a rack.
b. Place the clamp on the screw on the console unit frame and hand-tighten
the nut on top of the clamp.
cable-management arm. To avoid placing strain on the cables, secure the
cables by using the hook-and-loop fastener cable straps. Make sure that the
cable-management arm is in the extended position when you secure the
cables to it.