IBM 1U Installation And Maintenance Manual page 22

12
1U 17-inch Flat Panel Console Kit: Installation and Maintenance Guide
4. Adjust the outer slide-rail brackets to fit the depth of the rack cabinet, and then
attach the front of the slide-rail brackets to the rack cabinet, using four screws
from the miscellaneous hardware kit. Make sure that the slide-rail brackets
extend outside of the rack-cabinet mounting flanges.
Note: Do not install screws in the middle holes in the slide-rail bracket. These
holes are for the thumbscrews on the front of the console unit.
5. Loosely attach the back of the slide-rail brackets to the rack cabinet, using four
screws from the miscellaneous hardware kit. Make sure that the slide-rail
brackets extend outside of the rack-cabinet mounting flanges.
6. Tighten the two rail-adjustment screws on each of the outer rails if you
loosened them in step 3 on page 11.