IBM 1U Installation And Maintenance Manual page 25

12. Connect the video, keyboard, and mouse connectors to either a server or a
console switch in the rack cabinet. Connect the power cord to the short jumper
cord on the cable-management arm, and then connect the power cord to a
properly grounded electrical outlet or power distribution unit (PDU).
13. Fully extend the console unit from the front of the rack cabinet, and then neatly
route the cables within the rack cabinet and secure them with cable straps
along the way.
Important: To minimize the electrical interference from the video cable,
arrange the cable in figure-eight loops, as shown in the following
illustration. Secure the cable in the middle with a cable strap.
Do not coil the video cable as shown in the following illustration.
14. See Chapter 3, "TFT-LCD display" for information about operating the display.
See the keyboard documentation for information about operating the keyboard.
Chapter 2. Installing the console unit in the rack cabinet
Cable tie
15