IBM 1U Installation And Maintenance Manual page 54

10. Turn over the replacement console unit:
11. Route the keyboard-and-mouse cable:
44
1U 17-inch Flat Panel Console Kit: Installation and Maintenance Guide
a. Grasp the cable-management arm and the loose cables in one hand.
b. On the opposite end of the console unit, grasp the flat-panel display and
the console unit frame together with the other hand.
c. Carefully turn over the console unit.
Attention: When you route the keyboard-and-mouse cable, make sure that
the cable does not hang below the underside of the keyboard where it might
be damaged if it interferes with the devices in the rack space below the
console unit.
a. Route the cable through the slot on the left side of the cable-routing area
on the underside of the keyboard. Do not route the cable through any of
the other three slots. (See the following illustration.)
Note: In the following illustration, the console unit is turned over and is
placed on a table or other flat surface.
b. Push the keyboard-and-mouse cable through the slit in the plastic bushing
that you removed in step 2 on page 42 and push the bushing into the
cable-routing cutout in the console unit frame.