Before You Call For Service - Fisher & Paykel DH9060P2 User Manual

User warnings
Your dryer is capable of diagnosing a number of its own problems. It will sound a
continuous series of beeps and display a user prompt when it has a problem that you can
correct yourself. To stop the beeps sounding, press any button on the control panel. Do not
try to continue your drying cycle once you stop the noise. You must address the problem
the dryer is alerting you to.
Check the below table before you call for service.
PROBLEM DISPLAYED AS
Keylock is
activated
Clean lint
filter
Clean
condenser
filter
The lint and/
or condenser
filter is
blocked and
needs to be
emptied
The water
tank is full
and needs to
be emptied

BEFORE YOU CALL FOR SERVICE

WHAT TO DO
Press
Refer to page 24 'Cleaning the door lint filter'.
Refer to page 25 'Cleaning the condenser filter, foam
and evaporator grid'.
Empty the lint filter and then replace it.
Check the lint filter is not damaged.
Check there is nothing else stuck in the lint filter holder
which may be blocking the air flow.
Check the lint filter is in place correctly in your dryer.
Clean the condenser filter and the foam filter (refer
to 'Caring for your dryer'). Ensure the foam filter has
been replaced correctly on the condenser filter. Ensure
the condenser filter unit has been placed or replaced
correctly into your dryer.
If the error continues you may need to replace the filter
foam, refer to 'To clean the filter foam:' for details.
Check if the water tank is full.
Empty the water tank.
If using the drain hose, check whether the water tank
or drain hose is blocked.
Check the drain hose is still attached at the back
of the dryer, and is not kinked or squashed.
for two seconds to deactivate the .
KEYLOCK
31