Before You Call For Service - Fisher & Paykel DE8060P Installation Manual/User Manual

User warnings
Your dryer is capable of diagnosing a number of its own problems. It will sound a
continuous series of beeps and display a user prompt when it has a problem that you can
correct yourself. To stop the beeps sounding, touch any button on the control panel. Do not
try to continue your drying cycle once you stop the noise. You must address the problem
the dryer is alerting you to.
Check the below table before you call for service.
PROBLEM
Keylock is
activated
The lint filter
is blocked
and needs to
be emptied
The water tank
is full and needs
to be emptied
The condenser
needs to
be cleaned
The door is
not closed
Once you have addressed the issue the user prompt was alerting you to, try using your
dryer as per usual. If the issue persists, call your Fisher & Paykel trained and supported
service technician.

BEFORE YOU CALL FOR SERVICE

DISPLAYED AS WHAT TO DO
Touch
Empty the lint filter and then replace it.
Check the lint filter is not damaged.
Check there is nothing else stuck in the lint filter
holder which may be blocking the air flow.
Check the lint filter is in place correctly in your dryer.
Check if the water tank is full.
Empty the water tank.
If using the drain hose, check whether the water tank
or drain hose is blocked.
Check the drain hose is still attached at the back of
the machine, and is not kinked or squashed.
Clean the condenser, refer to the 'Cleaning the
condenser filter' section). Ensure the condenser unit
has been placed or replaced correctly into your dryer.
Close the door fully and touch
Try opening and closing the door again.
Reposition the load, ensure the load is correctly in the
drum and that protruding items are not stopping the
door from closing.
for 2 seconds to deactivate the .
KEYLOCK
.
35