Before You Call For Service - Fisher & Paykel DH8060P Installation And User Instruction Manual

User warnings
Your dryer is capable of diagnosing a number of its own problems. It will sound a
continuous series of beeps and display a user prompt when it has a problem that you
can correct yourself. To stop the beeps sounding, touch any button on the control panel.
Do not try to continue your drying cycle once you stop the noise. You must address
the problem the dryer is alerting you to.
Check the below table before you call for service.
PROBLEM
Keylock is
activated
The lint filter
is blocked
and needs to
be emptied
The water
tank is full
and needs to
be emptied
The door is
not closed
The drying
rack is not
in place
Once you have addressed the issue the user prompt was alerting you to,
try using your dryer as per usual. If the issue persists, call your Fisher & Paykel
trained and supported service technician.
24

BEFORE YOU CALL FOR SERVICE

DISPLAYED AS WHAT TO DO
Touch and hold the 'Keylock' button for 2 seconds
to deactivate the Keylock.
Empty the lint filter and then replace it.
Check the lint filter is not damaged.
Check there is nothing else stuck in the lint filter holder
which may be blocking the air flow.
Check the lint filter is in place correctly in your dryer.
Clean the condenser filter (refer to the 'Caring for your
dryer' section). Ensure the condenser filter unit has
been placed or replaced correctly into your dryer.
Check if the water tank is full.
Empty the water tank.
If using the drain hose, check whether the water tank
or drain hose is blocked.
Check the drain hose is still attached at the back
of the machine, and is not kinked or squashed.
Close the door fully and touch
Try opening and closing the door again.
Reposition the load, making sure the load is correctly
in the drum and that protruding items are not
preventing the door from closing.
Fit the drying rack.
.