Legal Information - Otto Bock 21Y14 Instructions For Use Manual

screw ring in the socket (Fig. 6). Tighten the upper screw ring. The pin
wrench can be used for tightening the lower and upper screw rings (Fig. 7).
• The lamination dummy is not needed here.
3.2 Instructions for use
3.2.1 PushValve
Place the PushValve upper part into the valve's base part by simply press-
ing. An audible feedback is emitted when the valve upper part has been
pressed in properly. To remove the valve upper part, press the air release
button, lift both wings with the thumb and index finger and pull the valve
upper part out of the base part.
3.2.2 MagValve
Place the MagValve upper part into the valve's base part by simply pressing.
An audible feedback is emitted when the contact between the magnet and
metal base has been established. To remove the valve upper part, press
the air release button and pull the valve upper part out of the base part.
3.3 Cleaning
The valve should be cleaned regularly with clear, warm water.

4 Legal information

All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
4.1 Liability
The manufacturer will only assume liability if the product is used in accor-
dance with the descriptions and instructions provided in this document.
The manufacturer will not assume liability for damage caused by disregard
of this document, particularly due to improper use or unauthorised modi-
fication of the product.
4.2 CE conformity
The product meets the requirements of Regulation (EU) 2017/745 on medi-
cal devices. The CE declaration of conformity can be downloaded from
the manufacturer's website.
Ottobock | 15