Removing The Switch From A Din Rail Or A Rack - Cisco Catalyst 2955 Hardware Installation Manual

Chapter 4 Installation in a Hazardous Environment

Removing the Switch from a DIN Rail or a Rack

Step 1
Step 2
78-14944-03
To remove the switch from a DIN rail or a rack, follow these steps:
Ensure that power is removed from the switch, and disconnect all cables and
connectors from the front panel of the switch.
Push down on the top of the DIN rail clip release tab with your finger. As the clip
releases, lift the bottom of the switch, as shown in
Figure 4-22 Removing the Switch from a Parallel Mounting Position
1 3
DIN rail clip
2 DIN rail
Removing the Switch from a DIN Rail or a Rack
DIN rail clip release tab
Catalyst 2955 Hardware Installation Guide
Figure 4-22 and Figure
1
2
3
4-23.
4-45