Cisco Catalyst 2955 Hardware Installation Manual page 85

Chapter 3 Installation
Use a ratcheting torque flathead screwdriver to torque the power and relay
Step 6
connector captive screws (above the installed wire leads) to 4.5 in-lbs. (72
ozf-in.). (See
Do not overtorque the power and relay connector captive screws. The
Caution
recommended maximum torque is 4.5 in-lbs.
Figure 3-8
1
78-14944-03
Figure 3-8.)
Torquing the Power and Relay Connector Captive Screws
Power and relay connector captive screws
1
Catalyst 2955 Hardware Installation Guide
Verifying Switch Operation
3-21