Chapter 3
Installation
Connecting to 100BASE-FX MM Ports
Warning
Caution
Step 1
78-14944-03
Class 1 LED product. Statement 1027
The 100BASE-FX MM fiber-optic uplink ports operate in full-duplex mode.
You can connect a 100BASE-FX port to a port on a target device by using one of
the MT-RJ fiber-optic patch cables listed in
part numbers in
Table B-1
Do not remove the dust plugs from the fiber-optic ports or the rubber caps from
the fiber-optic cable until you are ready to connect the cable. The plugs and caps
protect the fiber-optic ports and cables from contamination and ambient light.
Follow these steps to connect the switch to a MM 100BASE-FX device:
Remove the dust plugs from the 100BASE-FX port, as shown in
store them for future use. Remove the rubber caps from the MT-RJ patch cable.
Store them for future use.
Figure 3-36
Removing Dust Plugs from 100BASE-FX Ports
Table B-1 on page
to order the patch cables that you need.
1 0 0 B a
s e - F X
M M
1 3
1 4
Catalyst 2955 Hardware Installation Guide
Connecting to 100BASE-FX MM Ports
B-3. Use the Cisco
Figure
3-36, and
3-65