Cisco Catalyst 2955 Hardware Installation Manual page 102

Connecting the Switch to the Power Converter
Insert the line and neutral wire leads into the terminal block line and neutral
Step 3
connections (see
Ensure that only wire with insulation extends from the connectors.
Tighten the line and neutral terminal block screws.
Step 4
Figure 3-17
1
Set the input voltage selector on the power converter to 115 or 230 V, depending
Step 5
on your country voltage settings or the requirements for the AC receptacle that
you are using. (See
Connect the other end of the AC power cord to the AC outlet.
Step 6
Table 3-2
selector settings.
Catalyst 2955 Hardware Installation Guide
3-38
Figure 3-17). Make sure that you cannot see any wire lead.
Connecting AC Power to the Power Converter
A C P o
w e r C o
P W R -2 n v e rt e
9 5 5 -A C r
=
N
L
1
To AC power source
Table 3-2.)
lists power converter input voltages and the corresponding input voltage
Chapter 3 Installation
78-14944-03