Connecting To 100Base-Lx Sm Ports - Cisco Catalyst 2955 Hardware Installation Manual

Connecting to 100BASE-LX SM Ports

Connecting to 100BASE-LX SM Ports
Warning
Warning
Warning
Catalyst 2955 Hardware Installation Guide
4-52
You can connect a 100BASE-LX port to a port on a target device by using one of
the LC fiber-optic patch cables listed in
numbers in Table B-2
Follow these steps to connect the switch to a 100BASE-LX SM device:
Do not connect or disconnect cables to the ports while power is applied to the
switch or any device on the network because an electrical arc can occur. This
could cause an explosion in hazardous location installations. Be sure that
power is removed from the switch and cannot be accidentally be turned on, or
verify that the area is nonhazardous before proceeding. Statement 1070
Invisible laser radiation may be emitted from disconnected fibers or
connectors. Do not stare into beams or view directly with optical instruments.
Statement 1051
Avoid direct exposure to the laser beam. Statement 1012
Chapter 4
Table B-2 on page
to order the patch cables that you need.
Installation in a Hazardous Environment
B-4. Use the Cisco part
78-14944-03