ABB SmartTouch i-bus KNX Product Manual page 63

Commissioning of the KNX Function via DCA (from ETS5)
Switch-off value
■
Options:
The parameter is used to set the switch-off value of the proximity sensor.
Notice
The parameter is only available if the parameter "Use approximation to switch on
the display" and the "Use 1-bit output object for proximity function" are activated.
Notice
When activated, the switch-off value is first used when the panel switches into
the standby mode.
Activate communication object "Disable proximity" 1 bit
■
Options:
The parameter is used to activate the "Deactivate proximity" communication object.
Product manual 2CKA00xx73xxxxx
Off
On
Activated
Deactivated
│63