Table of Contents
Advertisement
Creating an individual time program
1. Switch to the individual time programs.
–
Aside from the corresponding time programs, the conditions under which the time
program becomes active are displayed in the time slots area.
2. Tap on the blue slider to make additional settings.
3. Specify the function of the control elements in the time program.
4. Then, in the pop-up, select the start time, the end time and the affected weekdays.
5. If necessary, enable the astro function.
–
This function can be used, for example, to automatically raise or lower the blinds a few
minutes earlier or later depending on the time of year.
–
The disabling function "Not before" and "Not after" fixes disabling times before or after
which no functions are carried out. For this the time can also be set via the scrolling
element.
6. Tap on the blue tick at the bottom right to confirm the settings.
–
The time program is then taken up into the time program list and can be edited there.
The available settings depend on the control element that is integrated in the
time program. This, for example, also allows the setting of colour ranges for
RGB lamps and corresponding values and steps for dimmers and fans.
Editing predefined time programs
If predefined time programs are used, they can be edited as follows:
Adjustment of function (e.g. switch on or off).
■
–
Use the arrow for the selection.
Adjusting the times:
■
–
Tap on the weekday. Then the timer setting opens again.
Specify the execution (always; on holiday; not on holiday).
■
–
Use the arrow for the selection.
Deactivation/activation of the time program.
■
–
Use the slider.
The adjustments become active immediately.
1. Select a predefined time program.
–
Aside from the corresponding time programs, the conditions under which the time
program becomes active are displayed in the time slots area.
2. Tap on the blue slider to make additional settings..
3. Specify the function of the control elements in the time program.
4. Then, in the pop-up, select the start time, the end time and the affected weekdays.
5. If necessary, open the astro function.
–
This function can be used, for example, to automatically raise or lower the blinds a few
minutes earlier or later depending on the time of year.
–
The disabling function "Not before" and "Not after" fixes disabling times before or after
which no functions are carried out. For this the time can also be set via the scrolling
element.
Product manual 2CKA00xx73xxxxx
Operation
│307
Advertisement
Table of Contents
