ABB SmartTouch i-bus KNX Product Manual page 62

Commissioning of the KNX Function via DCA (from ETS5)
Proximity sensor
Use approximation for switching on the display
■
Options:
When the checkbox is activated, a proximity is used as switch-on criteria for the display.
Sensitivity of the proximity function
■
Options:
The parameter us used to specify the sensitivity of the proximity function.
Notice
The parameter is only available if the parameter "Use approximation to switch on
the display" is activated.
Use 1-bit output object of proximity function
■
Options:
When the checkbox is activated, a 1-bit output object of the proximity function is used.
Notice
The parameter is only available if the parameter "Use approximation to switch on
the display" is activated.
Switch-on value
■
Options:
The parameter is used to set the switch-on value of the proximity sensor.
Notice
The parameter is only available if the parameter "Use approximation to switch on
the display" and the "Use 1-bit output object of proximity function" are activated.
Product manual 2CKA00xx73xxxxx
Activated
Deactivated
1
2
3
Activated
Deactivated
Off
On
│62