ABB SmartTouch i-bus KNX Product Manual page 61

Commissioning of the KNX Function via DCA (from ETS5)
Display brightness [%]
■
Options:
The parameter is used to set the display brightness in %.
Notice
The parameter is only available if the "Brightness is adjusted to the ambient
light" parameter is deactivated.
Switch off the display after [min]
■
Options:
The parameter is used to set after how many minutes the display is switched off.
Switch off the display when the room is dark
■
Options:
When the checkbox is activated, the display is switched off when the room is dark.
Brightness value for interpretation as dark
■
Options:
The parameter is used to specify the brightness value below which the brightness is interpreted
as dark (1 = dark - 5 = bright).
Notice
The parameter is only available if the parameter "Switch off the display when the
room is dark" is activated.
Switch off after [min] of darkness
■
Options:
The parameter is used to specify after how many minutes darkness the display switches off.
Notice
The parameter is only available if the parameter "Switch off the display when the
room is dark" is activated.
Product manual 2CKA00xx73xxxxx
10 - 100
1
2
5
10
15
30
Activated
Deactivated
1 - 5
1
2
5
10
│61